Advertisement
8.2.12 During saw blade change operations, use protective gloves
8.2.13 Saw must be selected according to standart DIN EN 847-1
8.2.14 A saw blade rotating in reverse direction, causes danger both for the operator and the equipment. The
teeth of the saw blade would be damaged and even broken.
8.3 Changing the belt
8.3.1 Cut the electric connection of the machine.
8.3.2 Also, remove M5 imbus screw (FIGURE 2 NO.98) with the aid of Allen switch by turning
(FIGURE 2 NO.64) manually. After removing the connections, remove the balancing wheel protection (FIGURE
2 NO.63) from its place.
8.3.3 Loosen the motor connection bolts (FIGURE 2 NO.100) with the aid of 13 mm switch.
8.3.4 Hold the belt tension part (FIGURE 2 NO. 59) from its part, which has a nozzle, to the switch with the aid of 12
mm switch. Loosen the M16 nut (FIGURE 2 NO.91) which is located on the belt tension part with the aid of 24
mm switch.
8.3.5 Get the belt tension part (FIGURE 2 NO.59) to off-position by turning it with the aid of a switch, have the belt
(FIGURE 1 NO.90) got loosen by pushing the motor (FIGURE 1 NO.60) forward.
8.3.6 Change the new belt with the previous one. Be careful when fixing the belt to the channels of balancing wheel
(FIGURE 2 NO.61/62) of the channels of the belt.
8.3.7 After having fixed the new belt to its place, set the tightness of the belt by holding the belt tension part (FIGURE
2 NO.59) with the aid of 12 mm switch. After adjusting it to the proper tightness, tighten M16 nut FIGURE 2
NO.91) with your free hand while still holding the part.
the plastic arm
50
Advertisement
