Advertisement
8.3.8 Tighten the motor connection bolts. (FIGURE 2 NO.100)
8.3.9 Fix the removed parts by following the reverse sequence that your removed them before.
8.4 Angular and run out adjustment control of saw blade and set sguare
8.4.1 Cut the electric connection of the machine.
8.4.2 Control the run out of the saw blade with eyes. İf possible use a dial gage.
8.4.3 If there is any problem in the inclined cut, control the saw's 90 degrees orthogonal to the set square with the aid
of the set-square. If it is not proper, loosen the stay bolt at the top which tightens the spring (FIGURE 1 NO.23) Have
the pin located to its place by turning the spring in way that it can provide it to be proper by setting it to the 90 degrees.
Tighten the screw at the top again which fastens the spring.
51
Advertisement
