Advertisement
8.2 Changing the cutting tool
8.2.1 Cut the electric connection of the machine.
8.2.2 Dismantle the blade guard group (FIGURE 2 N0.47) in the stipulated order.
8.2.3 Remove the segment (FIGURE 2 NO.96) on the protection sheet bar (FIGURE 2 NO.42). Set the end of the
protection sheet bar to off-position by removing it from the pin.
8.2.4 Remove the saw protection connection screws (FIGURE 2 NO.95) with the aid of philips screwdriver. Remove
the saw protection Group which is set to off-position.
8.2.5 Remove the M10 bolt (FIGURE 2 NO.97) from its place with the aid of 17 mm switch. While removing the bolt,
hold from the other end of the saw shaft (FIGURE 2 NO.50) with 8 mm Allen switch.
8.2.6 Remove the string (FIGURE 2 NO.51) and saw coupling (FIGURE 2 NO.54) respectively.
8.2.7 Take out the saw blade (FIGURE 2 NO.57) carefully.
8.2.8 Install the new saw blade onto the shaft ensuring the correct rotation direction.
8.2.9 Install the guard group parts applying the reverse order as described above.
8.2.10 It is necessary to sharpen / replace the saw blade in certain intervals depending on the cutting material. If the
cut material leaves burr after the cutting operation or if the saw blade is strained, it needs to be sharpened /
replaced.
8.2.11 When replacing the saw blade, use the part of the blade washer which is appropriate for the blade shaft
diameter. The outer diameter of the blade washer is 30 and 32 mm.
49
Advertisement
