Sx-300 Protocol Settings - Image Sensing Systems RTMS Echo User Manual

Chapter 4:

Sx-300 Protocol Settings

RTMS Echo User Guide
This function is used to set operating parameters allowing the RTMS Echo to
simulate an RTMS Sx-300.
1. Click the Settings tab.
2. In the Sx-300 protocol section, click change.
3. To put the sensor in Stat mode, select the check box. If unchecked, the
sensor is in polled mode.
In Stat mode, statistical messages are only transmitted at the end of every
message period.
In Polled mode, only statistical data that is currently stored in the Echo
buffer is transmitted and only when a matching sensor ID request is
received by the Echo sensor.
4. Select whether Gap or Headway data is to be included in the statistical
message.
5. If Speed 85th percentile data is to be included select the check box.
6. For Port, enter the port number to be used for communicating with the
Echo sensor. The default is 2000.
7. If a change was made, click Save changes.
©2019 Image Sensing Systems Inc.
Operations and Adjustments
4-51