Setting Up The Sensor - Image Sensing Systems RTMS Echo User Manual

Chapter 3:

Setting Up the Sensor

RTMS Echo User Guide
6. Undo the protective cap on the sensor's connector.
7. Insert the RJ-45 connector from the cable to the RJ-45 receptacle on the
bottom of the sensor.
RJ-45 receptacle on the
bottom of the sensor.
8. Tighten the cable's locking collar by turning it a quarter turn to the right.
Warning
Make sure the mains are turned off prior to connecting wires from the
Echo cable to the breakout box.
9. Connect the other end of the cable to power and communications in the
breakout box (see
The set up process consists of the following:
•
Logging in to the Sensor for the first time
•
Aiming the sensor
•
Detecting zones
•
Verifying vehicle counts
•
Configuring the settings
The following equipment and personnel will be needed in order to perform the
configuration process.
•
At least two persons
•
A hand-held tally counter
•
Light Detecting and Ranging (LIDAR) radar gun
•
Stop watch
©2019 Image Sensing Systems Inc.
Cable RJ-45 connector
"Connecting Power and Communications" on page
Sensor Installation & Setup
Cable locking collar
2-5).
3-4