Speed Calibration - Image Sensing Systems RTMS Echo User Manual

Chapter 4:

Speed Calibration

RTMS Echo User Guide
This function is used to adjust the vehicle speed detected by the Echo sensor
if required.
NOTE: RTMS Echo cannot be used for speed enforcement.
1. Click the Calibrate tab.
2. Click Speed Calibration.
3. Select the check box to the left of each zone for which speeds are to be
checked.
4. Click Start.
5. If the value in the Measured Speed column is not correct, enter the
difference in the Adjustment column.
The value must be expressed as a percentage between +/- 10 and must
be a whole number (e.g., 4 is OK but 4.5 is not).
All detected speeds for the lane will be adjusted by the amount specified.
6. To save the values, click Save.
©2019 Image Sensing Systems Inc.
Operations and Adjustments
4-16