AccuTemp Accu-Steam G2 Series Installation & Operator's Manual page 26

MODE LED Indicators
Set Preset All indicator LEDs
Temperature blinking. Then the
selected preset key
will blink for 3 -5
seconds.
Display Current Temperature
Temperature function LED on
Mode
User Lockout All LEDS on solid
Mode
MP5017-2002
DISPLAY
Set Point Value
Actual temperature
"Loc"or "ULoc"
Accu-Steam Gas Griddle
NOTES
Use the same process to change the
temperature as detailed in Set Temperature
(On the fly), to adjust the Set Temperature.
Once the correct temperature is displayed,
and before the five second time out, press
Preset Temp 1 key or the
and hold the
Preset Temp 2 key to save the displayed
value to the desired preset key and to exit
this mode. Press the
without saving.
Default Values:
Preset 1 = 375°F
Preset 2 = 400°F
Asterisk key and the
Pressing the
Arrow Key will display the current actual
temperature when the unit is in Ready Mode.
To Set USER LOCKOUT mode, press and
On/Off key and the
hold the
key for approximately four seconds while the
controller is ON. After four seconds, the
USER LOCKOUT parameter will toggle and
the display will show either "Loc" or "ULoc".
When buttons are released, the controller
will store the new USER LOCKOUT param-
eter value into NVM.
Up Arrow key (Increment) and the
Down Arrow key (Decrement) will be
inoperable and the user can't store new
values into the Preset 1 or 2 keys.
Up Arrow key or the
When
Arrow key (Set temperature on the fly mode)
are held for three seconds the display will
show "Loc" when in the "Loc" mode
On/Off key to exit
Up
Asterisk
Down
25