AccuTemp Accu-Steam G2 Series Installation & Operator's Manual page 15

1. Carefully remove the packing material of
the stand.
2. Locate the stand in an area where there is
room to work around If the stand model
has casters lock the front casters to the on
position
(Fig 3.B).
3. Using the lifting device make sure that
the plate or forks extend the width of the
griddle bottom to avoid damaging the
griddle (Fig 3.C).
4. Raise the lifting device enough to gain
access to the four shipping legs (Fig 3.D).
Fig 3.D
MP5017-2002
Fig 3.B
Fig 3.C
Accu-Steam Gas Griddle
5. Remove the two fasteners that attach each
of the four legs to the griddle and retain the
fasteners for later use (Fig 3.E).
6. Raise the lifting device so that the griddle
clears the mounting tabs of the stand (Fig
3.F). Align the holes in the four mounting
tabs of the stand to the threaded holes of
the griddle.
7. Locate the eight fasteners and lock washers
removed in step 6. Place a split lockwasher
on each bolt and push through the hole in
the mounting tab (2 holes per mounting
tab) and hand thread each into the griddle's
threaded holes. Verify that the fasteners are
not cross threaded (Fig 3.G).
Fig 3.G
Fig 3.E
Fig 3.F
14