AccuTemp Accu-Steam G2 Series Installation & Operator's Manual page 24

Managers mode is used to setup initial operational parameters for the appliance prior to the first
time of production use.
Manager's mode
1. Entering Managers mode, press and hold the
together for about eight seconds, to initiate the programming mode. When the mode is
accessed, all three LED lights will blink synchronously.
2. Once in managers mode, the display will show the DEFAULT COOK TEMP, (see Fig 4.E, P# 1)
3. To cycle between programs, use
reach Program #2, Ready Mode Display, the
Program #1 Default Cook Temperature to Program #2.
4. To adjust the selected program, use
Settings (Fig 4.E & 4.F).
5. When all changes are completed Exit the Managers mode and save the new parameters by
pressing the Preset 2 key
Mode P# LED1 LED2
0 B
1
B
2
B
This chart illustrates the programming logic and program level indication
P#2 Default
Value Display
0/00 rdY
1/00 Set Point Tempera-
ture
2/00 rdY
3/00 Set Point
Programming Example - Adjusting the Default Temp.
1. Press and hold the
seconds, to initiate the programming mode. When the mode is accessed, all three LED lights
will blink synchronously.
2. The display will show the default temperature (350°F from factory).
3. Use the use Preset 2 key or
display.
4. With the desired temperature displayed the
5. When the unit is restarted, the display will now show the new default temperature and start
heating.
MP5017-2002
LED3 Program description
B B Unit of Measure
B B Default Cook Tempera-
ture
B B Ready Mode Display (see
table below for further
detail)
Display when there is a
or momentary key press
Set Point Temperature
Set Point Temperature
rdY
Set Point Temperature
This chart illustrates details for Parameter 2 Mode Display
DOWN arrow key and the
Asterisk key to increase or decrease the temperature on the
Accu-Steam Gas Griddle
DOWN arrow key and the
UP arrow key and
UP arrow would be pushed once, cycling from
Preset 2 key or
Default
(°F)
350F
175C
0
Fig 4.E
, Display when there is a
Set Point Temperature
Actual Temperature
rdY
Set Point Temperature
Fig 4.F
Asterisk key together for about eight
Preset 2 key to save. The unit will power down.
Asterisk key
DOWN Arrow key. For example, to
Asterisk key to adjust the Program
Display Min Setting
0/00 0/00 = F
350F 200F
175C 90C
2/00 0
Max Setting
0/01 = C
400F
205C
3
key press
23