AccuTemp Accu-Steam G2 Series Installation & Operator's Manual page 25

4.2.3 CONTROL REFERENCE GUIDE
MODE LED Indicators
Off All LED's are off when
powered down.
Warm Up / Cool Blinking LED
Down above the selected
temperature key (LED
1, 2 or 3). If default
condition then LED 1.
If Preset 2 is selected
then LED 3 If Preset 1
then LED 2
Ready Mode LED above the
selected key will be
ON
Set Temperature All indicator LEDs
blinking
(On the fly)
Select Preset Selected Preset
indicator LED blinking
Temperature
MP5017-2002
DISPLAY
Off when powered down.
When powered On, the
controller would FLASH
at a 1 Hz rate the current
set temperature for 5
seconds. After this period
the controller would go
to Warm Up / Cool Down
Mode.
Actual temperature when
no keys depressed, or set
temperature of the
Preset/Manual key when
UP arrow key
key
Preset 1 key or
Preset 2 key is
momentarily pressed.
Default display and
alternate display options
will be determined
according to Program #2
value as shown in Fig 4.E
& 4.F
Set Point Value when
user Lock Mode is OFF,
or "Loc" when User Lock
Out Mode is ON
Set Point Value
Accu-Steam Gas Griddle
NOTES
To turn unit on: depress the
To turn off the unit, disable outputs, save the
current set point temperature (see details in
"Other Features") and turn off the display:
press and hold the On/Off key for
approximately five seconds.
Upon power-on or whenever another
temperature setting is made, the unit will
enter this mode and will exit this mode only
when the actual temperature has regulated.
Once has regulated, the indicator LED above
the selected key will go to solid ON. .For
details on display operation, please refer to
Program #2 value as shown in Fig 4.E & 4.F
If the User Lock Out Mode is OFF, the set
temperature can be adjusted. To set the
temperature, press either the
DOWN arrow key and hold
key or the
for approximately 3 seconds. The controller
will load and display Default Cook Temp and
enter set temperature mode. Press the
arrow key to increment or the
arrow key to decrement from the current
temperature setting. Wait for five seconds.
If there are no other key presses, the unit
will auto start to the new setting. Press the
On/Off key to exit without saving.
To select an alternate preset temperature, if
Preset Temp 1 setting, press
in
Temp 2 key and hold for approximately
three seconds. If in Preset Temp 2
setting, press Preset Temp 1 key and
hold for approximately three seconds.
On/Off key.
UP arrow
UP
DOWN
Preset
24