3. Connect the terminating resistor to the SILC DSL. See
4. Connect the ISDN BRI terminals to the DSL. See
5. Initialize the terminals. See
Connecting ISDN BRI terminals to the system
ISDN BRI terminals connected to the system.
Connecting ISDN BRI terminals to the system
Connecting system cables to the cross-connect terminal
Each card slot equipped with a SILC or UILC requires one NE-A25B 25-pair connector
cable.
ISDN Basic Rate Interface Installation and Commissioning
resistor to the SILC DSL
terminals to the DSL
on page 74.
page 77.
on page 72.
Initializing an Avaya M5317TDX terminal
on page 65 shows a typical DSL and multiple
Installation procedures
Connecting the terminating
Connecting the ISDN BRI
on
March 2011
65