Table of Contents
Advertisement
Installing ISDN BRI hardware
1. Hold the MISP by its card-locking devices. Squeeze the tabs to unlatch the card-
2. Carefully remove the MISP from its card slot, and slowly slide the card from the
Installing the BRSC, SILC, and UILC
After MISPs are installed, install SILCs, UILCs, and BRSCs, as required. As the cards are
installed, keep a list of the card type (BRSC, SILC or UILC), the module number, and the
number of the card slot containing the card. Use the Core/Network Module card location form
or the IPE Module card location form at the end of this chapter to document this information.
1. Hold the card by its card-locking devices. Squeeze the tabs to unlatch the card-
2. Insert the BRSC, SILC, or UILC into the selected card slot of the module so it
3. Slide the BRSC, SILC, or UILC into the module until it engages the backplane
4. Push the card firmly into the connector using the locking devices as levers by
5. Push the tabs firmly against the front panel of the card so they latch to the front lip
6. Observe the red LED located on the faceplate.
7. On the CE or IPE Module card location form, fill in the card type and the module
8. Repeat steps 1 through 7 for each card requiring installation.
Remove the BRSC, SILC, and UILC
Perform the following steps to remove the BRSC, SILC, and the UILC.
1. Hold the card by its card-locking devices. Squeeze the tabs to unlatch the card-
2. Carefully disengage the BRSC, SILC, or UILC from the backplane connector, and
Connecting ISDN BRI terminals to the system
To connect the ISDN BRI terminals to the system, perform the following steps.
22
ISDN Basic Rate Interface Installation and Commissioning
locking devices and lift the tabs out and away from the card.
module.
locking devices and lift them away from the card.
engages the card guides in the module.
connector.
pushing them toward the card's front panel.
in the module and to the post on the card.
• If the red LED turns on and stays lit continuously, the card is defective. Remove
the card, choose a new card, and repeat the installation procedure.
• If it flashes three times and then turns off, the card is operating correctly. Go
to step 7.
• If the red LED flashes three times and then stays lit continuously, the card is
operating correctly but is not configured. Go to step 7.
number next to the slot number of the installed card.
locking devices and lift them away from the card.
slowly slide the card from the module.
March 2011
Advertisement
Table of Contents
