Table of Contents
Advertisement
Installing ISDN BRI hardware
4. Install the S/T Interface Linecards (SILCs) and/or U Interface Linecards (UILCs) or
5. Connect ISDN BRI terminals. This procedure comprises the following:
Selecting the card slots
To install ISDN BRI cards, perform the following steps:
1. Identify all the slots that can contain the ISDN BRI cards. First identify the modules
2. Locate the card slots in the modules that house ISDN BRI cards. Group all SILCs,
3. For the Communication Server 1000E, make sure the MISP is in the same IPMG
16
ISDN Basic Rate Interface Installation and Commissioning
Basic Rate Signaling Concentrators (BRSCs).
• Connect the system to the Main Distribution Frame (MDF).
• Cross-connect the MDF.
• Connect ISDN BRI terminals to the DSL.
• Initialize the ISDN BRI terminals.
with unused network and peripheral card slots and then remove the covers from the
identified modules. To identify the modules, use the following Print Programs.
• LD 22 to print the system configuration and identify unused network card slots
to install MISPs
LD 22 REQ: prt TYPE: cfn
• LD 20 to list unused IPE card slots to install SILCs, UILCs and BRSCs
LD 20 REQ: prt TYPE: luc TN: l s
Table 1: ISDN BRI card location
BRI cards.
Table 1: ISDN BRI card location
Modules
NT4N41 Core/Network Module Large
NT8D35 Network Module
NT8D37 IPE Module
11c cabinet
NT414 chassis
MG1010
UILCs, BRSCs, superloops and the MISP that supports them in the same network
group to avoid using junctors for dedicated connections.
as the BRI cards.
on page 16 lists the modules that can house ISDN
Supported
SILCs, UILCs,
Systems
BRSCs
—
Systems
81C CPPII
—
All systems
IPE slots 0-15 —
slot 1–9
slot 1–4
slot 1–10
MISPs
Network slots
0-7
Network slots
5-12
slot 1–9
slot 1–4
slot 1–10
March 2011
Advertisement
Table of Contents
