Barco DP2K-19B Installation Manual page 44

4. Lamp & Lamp House
5
Image 4-21
8. Install the side cover of the Lamp House and fasten the three quarter turn screws (reference 4 image 4-22) of the cover.
Note: Please ensure that the quarter turn screws turning wires are flush with the cover or interference will occur while inserting
the Lamp House into the projector.
Image 4-22
9. Secure the xenon lamp cathode with the hexagon socket head cap screw (reference 1 image 4-23), spring washer (reference 2
image 4-23) and plain washer (reference 3 image 4-23). Fasten the screw with a torque of 5 Nm (3,7 lbf*ft). Use a torque wrench
with a 5 mm Allen socket.
Caution: Make sure that both pins (reference 11 image 4-23) of the cathode adapter remain engaged in the foreseen slots.
2
1
Image 4-23
C
AUTION
after each installation of an xenon lamp inside the Lamp House. Neglecting this update will result in poor
performance and short life time of the xenon lamp.
38
3
:
The "LAMP INFO" parameters which are stored on a chip inside the Lamp House MUST be updated
11
R5905067 DPXK-19B/23B/P 17/09/2012
4
5 Nm
5 m 5 Nm