Hvac Pre-Installation Checklist; Appliance Positioning; Airq Injection Locations - Prolitec AirQ 1280 Original Instructions Manual

HVAC Pre-installation Checklist

This checklist should be completed before the install date.
1. Confirm the area to be targeted for air treatment.
2. Determine the Air Handling Unit or duct that serves the target area.
3. Make sure the AHU does not use an open gas flame.
4. Find and mark the optimal insertion point for the Injector Tube. (See "Appliance Positioning")
5. Find and mark the exact location for placement of the appliance. (See "Appliance Positioning")
6. Note the distance between the insertion point and the proposed appliance location. (NEVER
MORE THAN 3 FEET and there should NEVER be a LOW POINT in the hose run.)
7. Determine and mark the location for the 110 or 220V AC power outlet (NEVER DIRECTLY
BELOW THE appliance).

Appliance Positioning

It is important to find an insertion point where the plume output will be smoothly drawn into and
mixed with the airflow. On larger AHU's it may be practical to mount the whole appliance inside the
AHU.
Best practice when installing in an AHU is to place the injector tube after the heating and cooling coils.
If this is not possible, the Plume output can pass over hot water, steam, chilled water, and DX coils.

AirQ Injection Locations

PREFERRED
< < < AIRFLOW < < <
1
< < < AIRFLOW < < <
AirQ 1280
1 2
< < < AIRFLOW < < <
2
FAN
EXCHANGER
< < < AIRFLOW < < <
INSTALLATION: DIffusion via HVAC System
3 4
AVOID
< < < AIRFLOW < < <
3
HEAT FILTER, SANITIZER,
HUMIDIFIER, ETC.
< < < AIRFLOW < < <
9
4
18