Related Manuals for Prolitec AirQ AQ570
Summary of Contents for Prolitec AirQ AQ570
- Page 1 P ERFEC T LY S C E N TE D E N V IR O NM E N TS Through Wall installation instructions Original Instructions Rev. 2019-01-04...
- Page 2 Contents Chapter 1: Tools Required Chapter 2: Unpacking Chapter 3: Assembly Chapter 4: Installation Positioning the Appliance Positioning the Plume Outlet Preparing the Appliance Connecting the Appliance Through Wall Kit...
-
Page 3: Tools Required
Tools Required 1. Stud finder 2. Drill 3. Phillips #2 bit 4. < 1/2” drill bit 5. Keyhole saw (not pictured) 6. 2 1/8” hole saw 7. Exacto knife (not pictured) Through Wall Kit Tools Required... - Page 4 Unpacking Remove all parts from the container. The following items should be included: 1. AQ570/580 Appliance (not pictured) b. Trim Ring Drywall Clips (2) 2. 110/220V to 15V Power Adapter (not d. 1 ¼” Screws (2) pictured) e. 3” Screws (2) (not pictured) Fan w/ 18”...
- Page 5 Assembly 1. Press fit the fan into the base housing part by aligning the three corner holes to the three hexagonal posts. 2. Insert the correct length screw (dependent on installation type) into the holes on the front of the base housing part, thread the drywall clips onto each screw, and tighten screws three or four turns.
- Page 6 3. Push one end of the tubing onto the fitting on the back side of the base housing part, just below the fan tray, and rotate the clips in toward the fan on both sides. 4. Wrap the wire around the tubing. 5.
-
Page 7: Installation
Installation Positioning the appliance in the “appliance mounting room” 1. Identify the area on the opposite side of the wall from the approximate mounting location. 2. Verify that you have an area of empty wall cavity, using a stud finder. 3. - Page 8 Positioning the plume outlet in the room to be scented 1. Drill a 2 1/8” hole, centered on the pilot hole, with the hole saw. 2. Insert the base housing, with the fan, clips, and tube already attached, into the hole. 3.
-
Page 9: Preparing The Appliance
4. Snap the trim ring over the front to hide the screws. Preparing the Appliance 1. Remove fan shroud Remove fan Cut fan wires at the fan Through Wall Kit Installation... - Page 10 Connecting the appliance in the “appliance mounting room” 1. Connect the wires of the fan assembly to the wires from the appliance, red to red and black to bl 2. Bundle the wires and tube inside of the sleeve. 3. Install the cartridge with the top plume port open. 4.