Set Black Mark Sensor As Media Sensor And Calibrate Black Mark Sensor29; Set Gap Sensor As Media Sensor And Calibrate The Gap Sensor; Skip Auto.bas - LabelStation CN User Manual

Parameter
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory No
4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate Black Mark Sensor
Follow the steps below.
1. Switch printer off.
2. Hold button down while switching power on.
3. Release button when LED shows alternating green/amber - 5 blinks. (Any time during the 5
blinks).

4.3.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Follow the steps below.
1. Switch printer off.
2. Hold button down while switching power on.
3. Release button when LED shows red/amber - 5 blinks. (Any time during the 5 blinks).

4.3.6 Skip AUTO.BAS

TSPL2 programming language allows users to download an auto execution file to flash memory. The
printer will run the AUTO.BAS program immediately when turning on printer power. The AUTO.BAS
program can be interrupted or prevented from running by the power-on utility.
Follow the procedures below to skip an AUTO.BAS program.
1. Switch printer off.
2. Hold button down while switching power on.
3. Release button when LED becomes solid green.
Default setting
127 mm/sec (5 ips) (203DPI) 76 mm/sec (3 ips) (300DPI)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
IP Address DHCP
29