Table of Contents
Advertisement
2. Feed the paper, printing side facing up, through the paper guide and pass over the platen.
3. Move the media guides to fit the label width by turning the guide adjuster knob.
4. Use the "Diagnostic Tool" or your labelling software to select and calibrate the appropriate media
sensor for your label type.
(If you use the "Diagnostic tool" click as follows: Select the "Printer Configuration" tab then click the
"Calibrate Sensor" button ).
Always be prepared to recalibrate the gap/black mark sensor after changing the media (label stock)
5. Open the peel-off panel by pulling it out.
Peel Off Panel
6. Lead the media through the backing paper opening, beneath the peel-off roller.
Peel-off roller
Backing Paper Opening
17
Advertisement
Table of Contents
