Table of Contents
Advertisement
Dump Mode
The printer will enter dump mode after printing the configuration. In dump mode, all characters are
printed in 2 columns as shown below. The left-hand column of data reflects the settings downloaded
from your system and the right-hand data shows their corresponding hexadecimal value. This allows
users and engineers to verify and debug the program.
ASCII data
Note:
1. Dump mode requires 4 inch wide label.
2. To resume normal printing, turn power off and on again.
3. Press the Feed button to go back to the previous menu.
4.3.3 Printer Initialization
Printer initialization is used to clear the DRAM and restore the printer settings to their defaults. The
only exception is ribbon sensitivity, which is not restored to default.
Printer initialization is activated by the following procedure.
1. Switch printer off.
2. Hold button down while switching power on.
3. Release button when LED shows green - 5 blinks. (Any time during the 5 blinks).
The defaults established are as follows:
Corresponding
Hex Decimal data
28
Advertisement
Table of Contents
