Note: This utility works with printer firmware V6.00 and later versions.
4. The Diagnostic Utility default interface setting is USB interface. If USB interface is connected with
printer, no other settings need to be changed in the interface field.
5. Click on the "Ethernet Setup" button from "Printer Function" group in Printer Configuration tab to
setup the IP address, subnet mask and gateway for the on board Ethernet.
3.6.2 Using RS-232 interface to setup Ethernet interface
1. Connect the computer and the printer with a RS-232 cable.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicking icon.
Note: This utility works with printer firmware V6.00 and later versions.
4. Select "COM" as interface then click on the "Setup" button to setup the serial port baud rate, parity
check, data bits, stop bit and flow control parameters.
21