Table of Contents
Advertisement
Features Tab
Printer Functions
Printer Status
3.5.2 Printer Function (Calibrate sensor, Ethernet setup, RTC setup etc.)
1. Select the PC interface type connected to the printer (typically USB).
2. Click the "Read" button followed by any appropriate Function button.
3. The Printer Functions are listed as below.
3.6 Setting Ethernet by Diagnostic Utility
Users can use the Diagnostic Tool to setup the Ethernet by RS-232, USB and Ethernet interfaces.
The following contents will instruct users how to configure the Ethernet by these three interfaces.
3.6.1 Using USB interface to setup Ethernet interface
1. Connect the USB cable between the computer and the printer.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicking on the icon.
Function
Calibrate Sensor
Ethernet Setup
RTC Time
Print Test Page
Reset Printer
Factory Default
Dump Text
Ignore AUTO.BAS
Configuration Page
Description
Calibrate the sensor specified in the Printer
Setup group media sensor field
Setup the IP address subnet mask gateway for
the on board Ethernet (Please refer to next
section)
Synchronize printer Real Time Clock with PC
Print a test page
Reboot printer
Initialize the printer and restore the settings to
factory default
To activate the printer dump mode.
Ignore the downloaded AUTO.BAS program
Print printer configuration details
20
Interface
Printer Setup
Advertisement
Table of Contents
