Table of Contents
Advertisement
Tear Bar/Peel Bar
1. Use lint-free cloth with ethanol to wipe it as needed.
Sensor
1. Gently blast with compressed air periodically to remove fluff and dust.
Exterior
1. Wipe with damp cloth as necessary.
Interior
1. Brush or carefully vacuum clean as needed to prevent build-up of dust and debris.
Notes:
1. Do not touch print head by hand. You will contaminate it and possibly burn yourself.
2. Always use 100% Ethenol. DO NOT use medical alcohol, which may damage the print head.
Lengthy continuous printing might cause the printer motor to overheat. Should this happen
the printer will stop automatically for about 10~15 minutes to cool down. Please don't turn off
the power during this process or data transferred to the printer buffer will be lost.
3. The maximum dot printing ratio per line is 15% for this printer. Therefore, to print a full
width, horizontal black line, the maximum line height is 40 dots. This equates to 5mm for the
203 DPI resolution printer and 3.3mm for the 300 DPI resolution printer.
32
Advertisement
Table of Contents
