Joystick Button; Horn Button; Heated Grips Switch (If Fitted); High Beam Button - Triumph Rocket 3 TFC 2020 Owner's Handbook Manual

General Information

Joystick Button

The Joystick is used to operate the
following functions of the instruments:
• Up - scroll the menu from the
bottom to the top
• Down - scroll the menu from the top
to the bottom
• Left - scroll the menu to the left
• Right - scroll the menu to the right
• Centre - press to confirm selection.

Horn Button

When the horn button is pushed, with
the ignition switch turned to the ON
position, the horn will sound.

Heated Grips Switch (if fitted)

The heated grips will only heat when
the engine is running.
When the heated grips are switched on,
the heated grips symbol will appear in
the display and the selected heat level
will be shown.
There are three levels of heat: low,
medium and high. This is indicated by
the different colours of the symbols
shown in the display.
1
1. Low heat symbol (yellow)
2. Medium heat symbol (orange)
3. High heat symbol (red)
68
2 3
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated
grips symbol is no longer shown in the
display.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips switch will power off. The heated
grips will not function again until the
voltage rises to a safe level.
The switch will not power back on
automatically even if the voltage rises to
the safe level. The user must manually
press the switch again to activate the
heated grips.

High Beam Button

The high beam button has a different
function depending on whether Daytime
Running Lights (DRL) are fitted or not.
When the high beam is turned on, the
high beam indicator light will illuminate
in the display.
Models with Daytime Running
Lights (DRL)
If the DRL switch is in the Daytime
Running Lights (DRL) position, then
press and hold the high beam button
to turn the high beam on. It will remain
on as long as the button is held in and
will turn off as soon as the button is
released.