Direction Indicator Switch; Joystick Button; Horn Button; High Beam Button - Triumph Speed Triple 1200 RS Owner's Handbook Manual

Press and hold the MODE button to
activate the ROAD mode, and enable
ABS and traction control, if disabled.
For more information on riding mode
selection and
page 46.

Direction Indicator Switch

When the indicator switch is pushed
to the left or right and released, the
corresponding
will flash on and off. To turn off the
indicators, push and release the switch
in the central position.
Models Equipped with Automatic Self-
Cancelling Indicators
A short press and release of the
indicator switch to the left or right
will cause the corresponding direction
indicators to flash on and off three
times, then turn off.
A longer press and release of the
indicator switch to the left or right
will cause the corresponding direction
indicators to flash on and off.
The indicators are automatically turned
off after eight seconds and after riding
a further 65 metres.
To disable the indicator self-cancel
system refer to the Bike menu section
on page 53 .
The indicators
manually. To manually turn off the
indicators, press
indicator switch in the central position.
configuration,
direction indicators
can be cancelled
and release
General Information

Joystick Button

The Joystick is used to operate the
following functions of the instruments:
• Up - scroll the menu from the
see
bottom to the top
• Down - scroll the menu from the top
to the bottom
• Left - scroll the menu to the left
• Right - scroll the menu to the right
• Centre - press to confirm selection.

Horn Button

When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.

High Beam Button

The high beam button has a different
function depending on whether Daytime
Running Lights (DRL) are fitted or not.
When the high beam is turned on, the
high beam indicator light will illuminate
in the display.
Models with Daytime Running Lights
(DRL)
If the DRL switch is in the Daytime
Running Lights (DRL) position, then
press and hold the high beam button
to turn the high beam on. It will remain
on as long as the button is held in and
will turn off as soon as the button is
released.
the
If the DRL switch is in the dip beam
position, press the high beam button to
switch the high beam on. Each press of
the button will swap between dip and
high beam.
61