Clutch Inspection; Final Drive Unit; Final Drive Unit Oil Level Adjustment - Triumph Rocket 3 TFC 2020 Owner's Handbook Manual

Maintenance
To inspect the clutch fluid level:
• Check the level of clutch fluid visible
in the window at the side of the
reservoir body.
• The clutch fluid level in the reservoir
must be kept between the MAX
(maximum) and MIN (minimum) level
lines (reservoir held horizontal).
To adjust the clutch fluid level:
• Clean the reservoir
removing. This helps to prevents dirt
and dust entering the reservoir.
• Remove the reservoir cap screws.
• Remove the reservoir cap, plastic
plate and the diaphragm seal.
• Fill the reservoir to the MAX level
line using new DOT 4 fluid from a
sealed container.
• Refit the diaphragm seal noting
that is correctly positioned in the
reservoir.
• Refit the plastic plate.
• Refit the reservoir cap.
• Refit and tighten the reservoir cap
screws to 1.5 Nm.

Clutch Inspection

Check that there is 2 - 3 mm clutch
lever free play at the lever.
If there is an incorrect amount of free
play, adjustments must be made.
128

Final Drive Unit

Check the final drive unit for oil leaks
in
maintenance chart.
Check the final drive unit for oil changes
in
maintenance chart.
Final Drive Unit Oil Level
Adjustment
cap before
Under no circumstances should the
final drive unit be disassembled.
Failure to observe this warning could
lead to a malfunction of the final drive
unit causing lock-up of the rear wheel
leading to loss of motorcycle control
and an accident.
1.
To adjust the oil level in the final drive
unit:
•
accordance with
accordance with
Warning
1
Filler level plug
Remove the filler level plug.
the scheduled
the scheduled