Triumph Rocket 3 TFC 2020 Owner's Handbook Manual page 47

Bike Setup - Hill Hold Control
(if fitted)
Hill hold control assists in making hill
starts. The system (when activated)
will apply the rear brake to hold the
motorcycle in position. The system
will then automatically deactivate and
release the rear brake when it detects
that the motorcycle is attempting to
move off.
To enable/disable hill hold control:
• from the Bike Set Up menu, push
the joystick down to select Hill Hold
and press the joystick centre to
confirm.
• Push the joystick down to select
either Enabled or Disabled.
• Press the joystick centre to confirm
the required selection.
• The display will then return to the
Bike Set Up menu.
For more information on hill hold
control, see page 103.
Bike Setup - TSA (Shift Assist)
(if fitted)
Triumph Shift Assist (TSA) triggers a
momentary engine torque change to
allow gears to engage. without closure
of the throttle or operation of the
clutch. This feature works for both up
shift and down shift of gears.
The clutch must be used for stopping
and pulling away.
TSA will not operate if the clutch is
applied or if an up shift is attempted
by mistake when in 6th gear. It is
necessary to use a positive pedal force
to make sure there is a smooth gear
change.
To enable/disable TSA:
• From the Bike Set Up menu, push
the joystick down to select TSA
(Shift Assist) and press the joystick
centre to confirm.
• Push the joystick down/up to select
either Enabled or Disabled.
• Press the joystick centre to confirm
the required selection.
• The display will then return to the
Bike Set Up menu.
For more information on Triumph Shift
Assist (TSA), see page 96.
Instruments
47