Cp.21 Last Error; Cp.29 Software Version; Cp.30 Software Date; Cp.31 Power Unit Code - KEB COMBIVERT R6 Instruction Manual

Special adjustments
No. Name
CP.21 last error
CP.22 last error -1
CP.23 last error -2
CP.24 last error -3
CP.25 last error -4
CP.26 last error -5
CP.27 last error -6
CP.28 last error -7
Parameters CP.21...CP.28 display the last eight errors. With exception error "undervoltage
E.UP" is not stored. The oldest error is displayed in CP.28. A new error is stored in CP.21.
All other errors are shifted to the next parameter. The oldest error (CP.28) is not applicable.
The meaning of the error messages is described in parameter CP.01.
No. Name
CP.29 software version
Value range
0.00...9.99
No. Name
CP.30 software date
Value range
0...6553.5
No. Name
CP.31 power unit code
The COMBIVERT R6-N detects the connected supply system (230 V/400 V) at the first
switching on. Depending on the supply system the COMBIVERT R6-S adjusts internally
certain parameter values.
If the COMBIVERT R6-N is connected to another supply system, these stored parameter
values are not valid any longer. Error message "power unit changed (E.Puch)" is displayed.
Value range
0...32767
No. Name
CP.32 puls off level
Value range
0.0...-1000.0 kW
48
Meaning
Display of the inverter software version number (e.g. 1,11).
Meaning
Display of the inverter software date in the format „ddmm.y".
Meaning
If the displayed value is written, only the power unit dependent param-
eters are re-initialised.
Standard Meaning
If the adjusted regenerative power is decreased, the COM-
-0.8 kW BIVERT R6-N switches the modulation off after turn-off de-
lay and changes into standby mode (display: „Stb").
r/w Enter based on
– – In.24 set 0
– – In.24 set 1
– – In.24 set 2
– – In.24 set 3
– – In.24 set 4
– – In.24 set 5
– – In.24 set 6
– – In.24 set 7
r/w Enter based on
– –
r/w Enter based on
– –
r/w Enter based on
– – Sy.03
r/w Enter based on
yes – cS.06
In.06
In.07