Placing Tool In Service; Specifications - Ingersoll-Rand 211 Instructions Manual

LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C26–C4–A29
For USA– No. C22–04–G00
After each eight hours of operation, unless an air line
lubricator is used, inject 1.5 cc of Ingersoll–Rand
No. 50 Oil into the inlet of the tool and run the tool
briefly.
After each forty–eight hours of operation, or as
experience indicates, inject about 3 cc of Ingersoll–Rand
No. 100 Grease into the Grease Fitting (19A, 31).
Model Type of
Handle
211, inline
211–EU
212, pistol
212–EU
H
Tested in accordance with ANSI S5.1–1971 at free speed
Tested to ISO8662–1 loaded with frictionbrake to 9 RPM
ISO3744

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 100

SPECIFICATIONS

Drive Impacts
per min.
in.
3/8" sq. dr., 1,500
ring–type
retainer
3/8" sq. dr., 1,500
ring–type
retainer
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft–lbs (Nm) Pressure
20–125 (27–170) 104.0
20–125 (27–170) 97.5
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
HSound Level
Vibrations
dB (A)
Power
117.0
110.5
Level
2
m/s
4.2
2.7