Warning Label Identification; Placing Tool In Service; Specifications - Ingersoll-Rand LA425-EU Instructions Manual

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
A good quality SAE 20 or 20W motor oil.
For International– No. C28–C4–FKG0
For USA– No. C28–04–FKG0–28
After each eight hours of operation, unless an air–line
lubricator is used, inject 1/2 cc of the recommended oil
into the air inlet.
Model
LA425–EU
LA435–EU,
LA435–2–EU
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested to ISO8662–1 loaded with frictionbrake to 9 RPM
•
ISO3744

WARNING LABEL IDENTIFICATION

90 psig
(6.2bar/620 kPa)

PLACING TOOL IN SERVICE

SPECIFICATIONS

Type of Drive
Handle
in.
pistol 1/2" sq.
pistol 1/2" sq.
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft–lbs (Nm) Pressure
25–275 (34–373)
25–275 (34–373)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
HSound Level
dB (A)
•Power
91.3 104.3
91.3 104.3
Level
2
m/s
3.6
3.6