Warning Label Identification; Placing Tool In Service; Specifications - Ingersoll-Rand 225 Instructions Manual

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
SETTING THE POWER REGULATOR
Impact wrenches are not torque wrenches.
Connections requiring specific torque must be checked
with a torque meter after fitting with an impact
wrench.
LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C28–C4–FKG0
For USA– No. C28–04–FKG0–28
After each eight hours of operation, unless the air line
lubricator is used, detach the air hose an inject about
1–1/2 cc of oil into the Inlet Bushing (6).
Model Type of
Handle
225 pistol
H
Tested in accordance with PNEUROP PN8NTC1.2
♦ Tested to ISO8662–7

WARNING LABEL IDENTIFICATION

90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
620 kPa) Maximum air pres-
sure.
ADJUSTMENTS

PLACING TOOL IN SERVICE

SPECIFICATIONS

Drive Impacts Recommended
per min.
in.
1/2" sq. 1350
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Model 225 Mini Impact Wrench incorporates a power
regulator into the reverse mechanism. To adjust the
power, rotate the Power Regulator (12) until the notch
aligns with the number of the desired power setting.
The numbers 1 thru 3 on the housing are only for
reference and DO NOT denote a specific power output.
One (1) designates the lowest power output while three
(3) denotes the highest.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
H
Torque Range
ft–lbs (Nm) Pressure
25–200 90.5
(34–271)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
Sound Level
dB (A)
Power
103.5
Level
2
m/s
2.9