Placing Tool In Service - Ingersoll-Rand 2131P Instructions Manual

LUBRICATION
Ingersoll–Rand No. 50
Ingersoll–Rand No. 115–1LB for routine external
lubrication of the impact mechanism through the Hammer
Case Grease Fitting.
Use Ingersoll–Rand No. 105–1LB or Ingersoll–Rand
105–8LB when disassembling and assembling the impact
mechanism.
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For USA – No. C18–03–FKG0–28
For International – C18–C3–FKG0
AIR SUPPLY (FROM COMPRESSOR)

PLACING TOOL IN SERVICE

3/8" COUPLER OR LARGER
(I–R PART NO. MSCF33)
I–R PART NO. MSPM32 (MALE)
I–R PART NO. MSPF32 (FEMALE)
3/8" AIR HOSE
WITH 1/4" NPT FITTINGS
Do not mark any nonmetallic surface on this tool with
customer identification codes. Such actions could affect
tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
I–R PART NO. MSPM32
3/8" COUPLER OR LARGER
(I–R PART NO. MSCF32)
(Dwg. TPD1674–2)