System Operation - JTS US-8001D Instruction Manual

6

System operation

Be sure to mute the audio signal of a mixer or ampli er before turning on the receiver and
transmi er.
(1) Power on
Turn AF level on the receiver completely counter-clockwise to the minimum level, and
switch on the receiver. As soon as you turn power of the receiver on, the power LED
lights red, meanwhile the RF signal and AF LED light up to indicate the receiver is ready
for operating. (Figure 3)
Always it' s a good idea to keep "open space" between transmi er and receiver, that will
improve RF reception.
(2) Selecting channel for the receiver and transmi er
1. Use the supplied screwdriver to select a desired channel for the receiver and transmit-
ters. Both receiver and transmi ers are preprogrammed with 16 channels.
2. Make sure the channel of receiver matches that of the transmi er.
3. When 2 or more transmi ers and receivers are being used in the same location, they
must be set up to use di erent channels. If existing channel is being interfered, please
change to another non-interference channel.
(Figure 3)
(Figure 4)
18