Tesla RoboStar T60 User Manual page 66

The vacuum cleaner
2 has been trapped
during cleaning.
The vacuum cleaner
interrupts cleaning and
3
prematurely returns to
the charging base.
The vacuum cleaner
4 does not start cleaning
as planned.
Remote control does
5 not work (RC working
range is 5 meters)
The vacuum cleaner has
been trapped in a small
area, the loose brushes
have been drilled on the
cleaning brushes, such as
power cords, curtains,
carpets etc.
If the battery level drops,
the vacuum cleaner
switches automatically to
the recharge mode dock
and returns to the charging
base.
The operating time varies
depending on the floor
surface, room complexity
and the selected cleaning
mode.
The vacuum cleaner is off or
the battery is running low.
You did not save the
planned cleaning in the
vacuum cleaner's memory.
The vacuum cleaner is
blocked.
Low batteries in the remote
controller.
The vacuum cleaner is not
turned on or does not have
a sufficiently charged
battery to start cleaning.
The infrared sensor of the
remote control is dirty or
the infrared sensor on the
vacuum cleaner is dirty.
There is interference
between the remote control
and the vacuum cleaner.
then let the battery recharge
normally.
The vacuum cleaner
automatically tries to release if
it is not able to clear the
obstacle yourself.
Normal status, let the vacuum
cleaner charge to full battery
capacity and start cleaning
again.
Normal state, no need to deal
with.
Turn on the vacuum cleaner
and recharge the battery.
Re-enter the time and day into
the vacuum cleaner's memory
and make sure the vacuum
cleaner is fully charged.
Turn off the vacuum cleaner
and clean it.
Replace the batteries, make
sure to insert the correct
polarity.
Make sure the vacuum cleaner
is on and recharge the vacuum
cleaner battery.
Clean the remote control and
the vacuum cleaner.
Avoid using in the vicinity of
other infrared devices.