Wet Mopping - Tesla Robostar T40 User Manual

5 The "HOME" (6) button
 Press to command the vacuum cleaner to search for the charging station and start charging.
When the button is pressed, or when a low battery is detected, the charging station is
searched. The Vacuum Cleaner searches for a signal from a station that is transmitted within
a radius of 1 to 2 meters around the charging base.
6 The "SPIRAL" (5) button

Press to command the vacuum cleaner to start cleaning in circles - targeted cleaning.
7 The "AUTO" (10) button

Press to command the vacuum cleaner to start automatic cleaning.
8 The "MAX" (8) button

Push to increase the suction power of the vacuum cleaner to the maximum power for deep
cleaning. This mode is used for larger floor contamination or thorough carpet cleaning.
CHARGING STATION

WET MOPPING

Attach the mopping pad with the mop on the vacuum cleaner, use the two installation holes "M"
on the bottom of the vacuum cleaner.
Remove the plastic cover and fill the plastic container with water. Lightly moisten the mop for
faster and smoother wiping. We recommend that the floor be wiped with clean water, the
detergent may cause foam to soften water dripping on the mop, or cause smudges on the floor
after drying.
1 Power indicator
2 230 V power adaptor
3 230 V power adaptor port connector
4 Charging pins