Tesla Robostar T40 User Manual page 30

If the mop is dirty after cleaning, you can clean it with lukewarm water. When removing the mop
from the holder, make sure you do not damage the velcro fastener on the bracket quickly.
1 Water container opening cover
2 Handle for removing the container
from the vacuum cleaner

Water should slowly drip from the left and right plastic parts.
 Press the top cover of the vacuum cleaner gently to open it, remove the dust container and
insert the water container instead.

The container should be properly inserted into its place in the vacuum cleaner.
 Close the top of the vacuum cleaner.

Press the "CLEAN" button to start the wet mopping operation.
 In this mode, the device does not vacuum, only the side brushes operate.
 Water drips automatically, so do not let the vacuum cleaner stand motionlessly in one place
with remaining water in the container to prevent water spillage on the floor.
 Do not use the microfiber cloth for mopping uneven surfaces or carpets.

Remove the water container when the mopping is done.
 Do not charge the battery with the water tank for safety reasons.
DRY MOPPING
 To remove fine dust and polish the floor.

Attach the mopping pad with the mop on the vacuum cleaner, use the two installation holes
"M" on the bottom of the vacuum cleaner.
 Do not use the microfiber cloth for mopping uneven surfaces or carpets.
DESCRIPTION OF THE STATUS LED DIODES
Status
Charging
Battery fully charged
Selected mode
Vacuum cleaner error
Low battery
Home mode
Cleaning mode
Edge cleaning mode
3 Opening for moistening the mop
4 Water container opening
LED's
All lights flash gradually
All lights turns solid
All lights flash slowly
All lights flash
The middle lights flash
The middle lights flash slowly
The middle lights turns solid
The middle lights turns solid, lower light flash