Disassembly - Icom ID-880H Service Manual

SECTION 3.
1. REMOVING TOP AND BOTTOM COVERS
1) Unscrew total of 18 screws; 4 screws from the top cover,
8 screws from the both sides and 4 screws from the
bottom cover.
2) Remove the top cover and bottom cover as illustrated
below.
Top cover
Bottom cover
2. REMOVING THE MAIN UNIT
1) Remove the IC clip from the chassis.
2) Disconnect the speaker cable from the MAIN UNIT, and
remove the speaker from the chassis.
IC clip
Speaker
DISASSEMBLY INSTRUCTION
SPEAKER
CABLE
<Top view>
(Continued to right above.)
2. REMOVING THE MAIN UNIT (continued)
3) Unscrew 10 screws from the MAIN UNIT.
4) Unscrew 4 screws from the chassis.
5) Disconnect the cooling fan cable from the MAIN UNIT.
6) Unsolder total of 4 points, and take off the MAIN UNIT.
UNSOLDER
Solder
remover
Screw x4
3. DISASSEMBLE THE CONTROL UNIT
1) Remove 3 knobs from the front panel.
Knobs
2) Unscrew 4 screws from the rear panel.
3) Remove the LCD plate.
4) Take off the CONTROL UNIT from the front panel.
Rear panel
CONTROL UNIT
Front panel
3 - 1
COOLING
FAN CABLE
MAIN UNIT
Screw x10
<Bottom view>
Front panel
Screw x4
LCD plate