Christie D Series Service Manual page 97

2. Attach the POWER UNIT BALLAST and AC WATCH PCB.
1) Turn over the BALLAST SHEET, and then slide the BALLAST unit to insert its two corners into
the slits of the BALLAST HOLDER.
2) Turn the BALLAST unit and insert another corner of it into the slit of the BALLAST HOLDER.
3) Close the BALLAST SHEET to set in place, and screw it down with the BALLAST unit. Pass the
cable to connect with the POWER UNIT CIRCUIT (CNPFC) through the hole of sheet.
4) Attach the AC WATCH PCB in place, and fasten it with 2 screws.
Slits BALLAST SHEET
POWER UNIT BALLAST
3.
4. Connect the AC power cable (CNAC) from the AC INLET.
1) Slide up the BALLAST SHIELD a little to align the holes of BALLAST HOLDER and BALLAST
SHIELD. And then, insert the connector housing of CNAC into the hole.
2) Connect the CNAC to the POWER UNIT CIRCUIT as shown in the picture.
POWER UNIT CIRCUIT
of the BALLAST HOLDER before tightening screws.
6. Set the BALLAST HOLDER and the BALLAST SHIELD onto the
POWER UNIT CIRCUIT, and then fasten them with three screws.
Screw
(M3x6, W/ washer,
silver, 0.69~0.88N·m)
2 Screws
(M3x6, W/ washer,
silver, 0.49±0.1N·m)
(M4x8, W/ washer, silver, 0.69~0.88N·m)
7. Screw down the ring end of the earth cables.
1) Fasten the ring end of CNAC by the detent with a screw.
2) Fasten the earth cable CNGD3 by the detent with a screw.
Wiring
Refer to page between 52 and 54 for wiring.
LWU720i/LHD720i/LWU620i Service Manual
LWU720i / LHD720i / LWU620i
BALLAST SHEET
Slits
CNPFC
POWER
SUPPLY
BOX
Screw
CNPFC
Hole
0.69~0.88N·m)
CNAC
Hole
BALLAST
SHIELD
CNGD3
Screw
(M3x6, W/ washer, silver,
0.69~0.88N·m)
CNAC
BALLAST
SHIELD
96