Christie D Series Service Manual page 81

Replacement of LENS and LENS ADAPTER PCB
ATTENTION
ADAPTER PCB are not bent before attaching the
LENS to the projector. The LENS ADAPTER PCB is
attached to the entry side of the LENS.
NOTE:
The type of the LENS ADAPTER PCB is
different depending on the lenses, standard
lens and each of optional lenses. The number
of the PCB is indicated with chip registers in
"7-segment display" method as on the right.
Assembling
NOTE:
Keep the lens hole cover for future use.
2.Remove the front cover
Slide the front cover (the upper part) upward while pressing the front cover from the underside
and remove the front cover from the projector.
Then, slide the front cover (the lower part) downward while pressing the front cover from the
upperside and remove the front cover from the projector.
(continued on next page)
LWU720i/LHD720i/LWU620i Service Manual
LWU720i / LHD720i / LWU620i
SL-712CH: 0
ML-713CH: 1
LL-704CH: 2
lens hole cover
Front cover
(upper part)
Front cover
(lower part)
LENS ADAPTER PCB
2 screws
0.15~0.20 N·m)
LENS
(LPA side)
UL-705CH: 3
7-segment
FL-701CH: 4
FL-710CH: 7
display
80