Christie D Series Service Manual page 49

6-18 Status Monitor
The Status Monitor is the sub LCD in the rear panel. The Status Monitor
displays the present condition of the projector including errors, setup infor-
mation and error history.
NOTE:
monitor are available while the projector is in standby mode if the STAND-
BY MODE item of SETUP menu is set to POWER SAVE.
contents on the Status Monitor are displayed upside down.
Displaying the condition of the projector
If no buttons have been operated, the Status Monitor displays as below depending on the condition
of the projector.
In a normal state
The Status Monitor displays the state of the projector in three lines.
1st line
: Displays the condition of the projector. While the lamp is on,
the selected port is displayed.
Displayed conditions are as below;
STANDBY: The projector is in standby mode.
WARM UP: The projector is warming up.
SEARCHING: The projector is searching an input signal.
COOL DOWN: The projector is cooling down.
: Displays the condition of the detected input signal while the lamp is on. Otherwise, dis-
2nd line
plays the serial number of the projector.
Displayed conditions are as below;
SYNC OUT
NO SIGNAL: There is no input signal.
CONNECTED
ferred to the projector while the LAN port is selected.
HOLD
lected.
NOT CONNECTED
selected.
: Displays supplied voltage and peripheral temperature in Celsius while the lamp is on.
3rd line
NOTE:
2nd line of the monitor.
temperature is measured inside of the projector.
LWU720i/LHD720i/LWU620i Service Manual
LWU720i / LHD720i / LWU620i
Status Monitor
S T A N D B Y
# 1 2 3 4 5 6 7 8 9 0 A B
2 3 ° C
example
LAN port is se-
LAN port is
48
-