Christie D Series Service Manual page 109

BOTTOM CASE
Disassembling
Remove 12 screws and detach the bottom metal.
NOTE:
Remember to detach the bottom metal and re-use
them with new BOTTOM CASE.
The service parts do not include the metal.
Fix the LIMIT SW PCB so that it can
be under the rib.
It is not allowed that it is hooked by the
rib or it rides over the rib.
#1156
#1155
When fixing (#1155), be sure to pass
these pins through the two holes of (#1155)
and fasten the screw (#1156) with pressing
the screw fastening surface.
Riding over the pin is not allowed.
Execute the visual confirmation shown in
figure A to prevent malfunction of the
LIMIT SW after fastening the screw.
LWU720i/LHD720i/LWU620i Service Manual
LWU720i / LHD720i / LWU620i
Assembling
Put the bottom metal on the BOTTOM CASE
shown in the drawing.
NOTE:
Figure A Confirmation method of the LIMIT SW
View of the
LIMIT SW from the
bottom of the set.
12 screws
(T2P_3x8BD+,0.69~0.88N∙m)
BTM CASE hole
Make sure that the entire tip of the LIMIT
SW (white) can be seen through the hole.
It is not allowed that only a part of the tip
can be seen.
108