Installing The Cable Strain-Relief Brackets; Chassis Description; Front Panel - 3Com NETBuilder II Installing Instruction

3-8 C 3: NETB
HAPTER UILDER
Installing the Cable
Strain-Relief Brackets

Chassis Description

Front Panel

II 8-S E B /R
LOT XTENDED RIDGE OUTER
The Extended chassis comes with two cable strain-relief brackets, which must
be mounted above and below the module slots. Figure 3-9 shows how to
install these brackets. Always use the cable strain-relief brackets with the
Extended chassis.
Align thumbscrews on strain-relief
brackets with holes in chassis
at top and bottom of module slots,
then tighten brackets to chassis.
Figure 3-9 Installing the Cable Strain-Relief Brackets on the Extended Chassis.
This section describes the basic hardware and accessories of the NETBuilder II
Extended chassis.
The Extended chassis front panel includes:
A 2-line, 24-character alphanumeric LCD.
6 status LEDs.
An access door to the floppy disk drive and the LCD control panel.
Figure 3-10 shows the front panel of the Extended chassis with the access door
open to show the floppy disk drive and the LCD control panel.