Upgrading From An Ultra 30 Or An Ultra 60 System; Powering Off The Ultra 60 System - Sun Microsystems Ultra 80 Upgrade Manual

3
C H A P T E R
Upgrading from an Ultra 30 or an
Ultra 60 System
This chapter contains procedures to power off the Ultra 30 or Ultra 60 system, open
the system, and to remove memory and graphics cards for transfer to a Sun Ultra 80
system. Illustrations in this chapter show an Ultra 60, but the Ultra 30 uses the same
procedural steps.
This chapter contains the following topics:
Section 3.1 "Powering Off the Ultra 60 System" on page 3-1
Section 3.2 "Removing the Ultra 60 Side Access Cover" on page 3-3
Section 3.3 "Attaching the Wrist Strap" on page 3-4
Section 3.4 "Removing an Elite3D Graphics Card" on page 3-6
Section 3.5 "Removing Ultra 60 DIMMs" on page 3-8
Section 3.6 "Replacing the Ultra 60 Side Access Cover" on page 3-12
3.1

Powering Off the Ultra 60 System

Caution – Before turning off the system power, exit from the operating system.
Failure to do so may result in data loss.
Caution – Wear an antistatic wrist strap and use an ESD-protected mat when
handling components. When servicing or removing system components, attach an
ESD strap to your wrist, then to a metal area on the chassis, and then disconnect the
power cord from the system and the wall receptacle. Following this caution
equalizes all electrical potentials with the system.
3-1