Heat & Glo SL-3X-IFT Installation Manual page 63

Install Front Logs
4. Remove small burner log from packaging. This log
has two holes on the bottom. These holes correspond
to two log pins located on the burner top. Place the
small burner log on the two log pins. See Figure 6.
When properly placed, this log will rest on both the
burner and ember tray/Teco-Sil.
Figure 6. Burner Log Installed
5. Remove top left log from packaging. Place the log
into the indentation on the rear left log. The right tip
of the log will rest on the ember tray and the Teco-Sil
rock. See Figure 7 and Figure 8.
SL-9X Models Only: Additional features were added
to the left indentation in the left rear log and the bottom
end of the top left log to best locate log.
INDENTATION-LEFT LOG INDENTATION-LEFT LOG
Figure 7. Location of Left Log indentation
Heat & Glo • SL-3X-IFT, SL-5X-IFT, SL-7X-IFT, SL-9X-IFT Installation Manual • 2472-980 Rev. Q • 3/20
INDENTATIONS-RIGHT LOG INDENTATIONS-RIGHT LOG
Figure 8. Location of Right Log Indentation
6. Remove top right log from packaging. There are
indentations located in the right rear log and small
burner log to locate the log. Place log into indenta-
tions as shown in Figure 8 and Figure 9.
Figure 9. Top Right Log Installed - Log Set Complete
INDENTATION INDENTATION
2372-935F
63