Table of Contents
Advertisement
CAUTION! Risk of Fire! DO NOT store instruction manuals inside fireplace cavity.
High temperatures could cause a fire.
INSTALLER: Leave this manual with the appliance, not inside the appliance.
CONSUMER: Retain this manual for future reference. Do not store inside the appliance.
Contact your dealer with questions regarding installation, operation or service.
NOTICE: DO NOT discard this manual!
Models:
This appliance may be installed as an OEM
installation in manufactured home (USA
only) or mobile home and must be installed
in accordance with the manufacturer's
instructions and the Manufactured Home
Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States, or the
Standard for Installation in Mobile Homes,
CAN/CSA Z240 MH Series, in Canada.
This appliance is only for use with the type(s)
of gas indicated on the rating plate. This
appliance is not convertible for use with other
gases, unless a certified kit is used.
Owner's Manual
Operation and Maintenance
Heat & Glo • SL-3X/5X/7X/9X-IFT (-G, -TG, -S) Owner's Manual • 2633-981 • 5/20
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
• DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Leave the building immediately.
- Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
- If you cannot reach your gas supplier, call
the fire department.
• Installation and service must be performed
by a qualified installer, service agency, or the
gas supplier.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.
Decorative barrier front must be ordered separately at
time of appliance purchase.
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
1
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Heat & Glo SL-3X-IFT Series
Summary of Contents for Heat & Glo SL-3X-IFT Series
- Page 1 Owner’s Manual Operation and Maintenance CAUTION! Risk of Fire! DO NOT store instruction manuals inside fireplace cavity. High temperatures could cause a fire. INSTALLER: Leave this manual with the appliance, not inside the appliance. CONSUMER: Retain this manual for future reference. Do not store inside the appliance. Contact your dealer with questions regarding installation, operation or service.
-
Page 2: Welcome
Welcome Read this manual before operating this appliance. Please retain this Owner’s Manual for future reference. Read the Installation Manual before making any installation or finishing changes. A. Congratulations This owner’s manual should be retained for future reference. We suggest that you keep it with your other Congratulations on selecting a Heat &... -
Page 3: Table Of Contents
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. •... -
Page 4: Limited Lifetime Warranty
B. Limited Lifetime Warranty Hearth & Home Technologies LIMITED LIFETIME WARRANTY Hearth & Home Technologies, on behalf of its hearth brands (“HHT”), extends the following warranty for HHT gas, wood, pellet and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within two years following the date of original purchase, that the HHT appliance will be free from... - Page 5 B. Limited Lifetime Warranty (continued) WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. •...
-
Page 6: Product Specific Information
Product Specific Information A. Appliance Certification B. Glass Specifications This appliance is equipped with ceramic glass. Replace MODELS: glass only with ceramic glass. Please contact your dealer SL-3X-IFT-G SL-3X-IFT-TG SL-3X-IFT-S for replacement glass. SL-5X-IFT-G SL-5X-IFT-TG SL-5X-IFT-S C. BTU Specifications SL-5XLP-IFT-G SL-5XLP-IFT-TG SL-5XLP-IFT-S SL-7X-IFT-G... -
Page 7: Important Safety And Operating Information
Important Safety and Operating Information A. Appliance Safety • Consider not using the fireplace when children will be present. WARNING! DO NOT operate fireplace before reading Contact your dealer for more information, or visit: www. and understanding operating instructions. Failure hpba.org/Product-Info/Fireplace-Stove-Heater/Glass- to operate fireplace according to operating instructions Fronts-Safety. -
Page 8: General Operating Parts
B. General Operating Parts D. Wall and Mantel Temperatures ANSI/CSA Standards Figure 3.2 references the general operating parts of the The American National Standards Institute (ANSI) and appliance and the section of this manual in which they are Canadian Standards Association (CSA) write the safety discussed. -
Page 9: Lighting Instructions (Ipi)
G. Lighting Instructions (IPI) FOR YOUR SAFETY READ BEFORE LIGHTING WARNING • Immediately call your gas supplier from a neighbor’s phone. Follow the gas sup- A. This appliance is equipped with an intermittent pilot ignition (IPI) device which plier’s instructions. automatically lights the burner. -
Page 10: Appliance Break-In
H. Appliance Break-In I. Heat Management Follow the initial break-in procedure below to cure the Heat Output materials used to manufacture the fireplace and the Heat output may be controlled on the SL-X-IFT series finishing materials around it. models by adjusting the “FLAME” setting and “FAN” setting •... -
Page 11: Operation During A Power Outage - Intellifire Touch
J. Operation During A Power Outage - To Return to Operation Using Electrical (AC) Power Intellifire Touch ® Standard Wall Switch or Factory-Installed ON/OFF Switch: The Intellifire Touch intermittent pilot ignition system ® • Toggle the switch to OFF and remove the batteries comes with a battery backup system that enables the from the battery tray. - Page 12 K. Detailed Component Operating 3. The Pilot button on the IFT-ECM activates the Cold Climate function of the fireplace. This function lights Instructions - IntelliFire Touch the pilot flame ONLY to provide enough heat in the IFT-ECM Detailed Operating Instruction firebox to reduce condensation in cool, high humidity ambient conditions.
- Page 13 Appliance ON/OFF: - Wait five (5) minutes to allow possible accumulated gas to clear. Your SL-X-IFT Series fireplace is supplied with a fully - Set the IFT-ECM 3-position selector switch to ON functional remote control. This remote controls the: or REMOTE position. Module will beep once and flash a three GREEN LED code on successful •...
-
Page 14: Maintenance And Service
Maintenance and Service Glass Cleaning IMPORTANT! Any safety screen, decorative barrier front or guard removed for servicing must be replaced prior to Frequency: Seasonally operating the fireplace. By: Homeowner When properly maintained, your fireplace will give you Tools Needed: Protective gloves, gas fireplace glass many years of trouble-free service. - Page 15 Venting and Termination Cap Frequency: Seasonally By: Homeowner Tools needed: Protective gloves and safety glasses. LATCHES • Inspect exposed venting and termination cap for block- (BOTH BOTTOM AND TOP) age or obstruction such as plants, bird nests, leaves, snow, debris, etc. GLASS •...
-
Page 16: Maintenance Tasks - Qualified Service Technician
C. Maintenance Tasks - Qualified Service Pilot and Burner Ignition and Operation Technician Frequency: Annually The following tasks must be performed by a qualified ser- By: Qualified Service Technician vice technician. Tools needed: Protective gloves, vacuum cleaner, whisk Gasket Seal and Glass Assembly Inspection broom, flashlight, voltmeter, indexed drill bit set, and a manometer. - Page 17 Figure 4.2 IPI Pilot Flame Patterns NOTE: Appearance of rock jig, pilot shield and media tray may vary between appliance models. LED Replacement Frequency: As needed By: Qualified Service Technician Tools needed: Protective gloves, replacement LED assemblies The LEDs installed in this appliance do not require any annual service.
-
Page 18: Frequently Asked Questions And Troubleshooting
Frequently Asked Questions and Troubleshooting A. Frequently Asked Questions - Appliance ISSUE SOLUTIONS This is a result of gas combustion and temperature variations. Prior to appliance being turned on, the inside of the glass has cooled below the dew point producing a byproduct of combus- tion: water in the form of condensation. -
Page 19: Frequently Asked Questions - Intellifire Touch Controls (Ift-Rc400)
B. Frequently Asked Questions - IntelliFire Touch Controls (IFT-RC400) Symptom Possible Cause Corrective Action The appliance does not respond to Batteries are depleted. Verify batteries are new. commands from the remote control display does not light up when Batteries are incorrectly Verify batteries are installed in correct orientation as shown on screen is touched. -
Page 20: Troubleshooting
C. Troubleshooting With proper installation, operation, and maintenance your gas appliance will provide years of trouble-free service. If you do experience a problem, this troubleshooting guide will assist a qualified service technician in the diagnosis of a problem and the corrective action to be taken. This troubleshooting guide can only be used by a qualified service technician. Contact your dealer to arrange a service call by a qualified service technician. - Page 21 IntelliFire Touch - (continued) Symptom Possible Cause Corrective Action Verify incoming gas line ball valve is ‘Open’. Verify inlet pres- No gas supply. sure is within requirement for gas type used. Contact gas sup- plier. Pilot sparks but does not light, after Verify wiring, check valve harness black wire is securely ECM has poor ground.
-
Page 22: Reference Materials
Reference Materials A. Accessories Optional Heat Management Systems Kits Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- After a qualified service technician has installed the heat proved accessories. management system, follow the instructions supplied with WARNING! Risk of Fire and Electric Shock! Use ONLY the kit for operation. -
Page 23: Service Parts
SL-3X-IFT (-S, -TG, -G) B. Service Parts Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active Log set Assembly IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or Stocked distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. - Page 24 SL-5X/LP-IFT (-S, -TG, -G) Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active Log set Assembly IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Stocked Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
- Page 25 SL-7X/LP-IFT (-S, -TG, -G) Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active Log set Assembly IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or Stocked distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
- Page 26 SL-9X/LP-IFT (-S, -TG, -G) Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active Log set Assembly IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or Stocked distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
- Page 27 Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active 14.1 #14 Valve Assembly 14.2 14.20 14.4 14.21 14.19 14.3 14.5 14.6 14.18 14.7 14.17 14.8 14.9 14.16 14.10 14.11 14.15 14.14 14.12 14.13 IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers.
- Page 28 Service Parts Beginning Manufacturing Date: July 2020 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth Stocked and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
-
Page 29: Contact Information
C. Contact Information Heat & Glo, a brand of Hearth & Home Technologies 7571 215 Street West, Lakeville, MN 55044 www.heatnglo.com Please contact your Heat & Glo dealer with any questions or concerns. For the location of your nearest Heat & Glo dealer, please visit www.heatnglo.com.
Need help?
Do you have a question about the SL-3X-IFT Series and is the answer not in the manual?
Questions and answers