Heat & Glo SL-3X-IFT Installation Manual page 59

REAR REFRACTORY "LEGS" REAR REFRACTORY "LEGS"
Figure 11.3 Install Rear Refractory Piece
4. Install left refractory panel until it contacts the back
wall refractory. See Fig 11.4.
Figure 11.4 Install Left Refractory Panel
5. Install top refractory by inserting into the firebox and
placing the left side on top of the left refractory panel
as shown. See Fig 11.5.
6. Push "UP" on top refractory and install right side re-
fractory panel as shown in Figures 11.6 & 11.7.
7. Installation is complete when top refractory panel is
set securely in place. Top refractory panel may need
to be pulled down to fit correctly. Chamfers should
properly fit together and gaps should be minimized
with correct installation.
Note: The grout line should match consistently between
the left, right, and rear refractory. If grout lines are not
aligned, verify that hearth components are pushed down
firmly to ensure proper side refractory fit. Additionally,
excess flashing or debris on hearth components may affect
side fit and grout orientation. It is acceptable to remove
excess flashing on the left and right hearth components
to best align grout lines.
Heat & Glo • SL-3X-IFT, SL-5X-IFT, SL-7X-IFT, SL-9X-IFT Installation Manual • 2472-980 Rev. Q • 3/20
Figure 11.5 Install Top Refractory Panel
Figure 11.6 Install Right Refractory Panel
Figure 11.7 Right Refractory Panel Installed
59