Table of Contents
Advertisement
www.ti.com
9.2
Setting Up the ADS1274EVM-PDK
The ADS1274EVM-PDK contains both the ADS1274EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1274EVM-PDK.
Step 1. Unpack the ADS1274EVM-PDK kit.
Step 2. Set the jumpers and switches on the MMB0 as shown in
•
Set the Boot Mode switch to USB.
•
Connect +5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
•
Leave +5V and +VA disconnected on jumper block J13.
•
If the PDK will be powered from an AC adapter, connect J12. If the PDK will be powered
through the terminal block, disconnect J12. (See
power supply.)
SBAU134A – August 2008 – Revised May 2009
Submit Documentation Feedback
Figure 9. MMB0 Initial Setup
ADS1174EVM, ADS1274EVM, ADS1174EVM-PDK, and ADS1274EVM-PDK
ADS1274EVM-PDK Kit Operation
Figure
9.
Section 9.3
for details on connecting the
13
Advertisement
Table of Contents
