Menu Navigation; Standard Test Tool Setup - Fluke ScopeMeter 190 II Series Service Manual

Menu Navigation

During verification you must open menus and choose items from the menu.
Proceed as follows to make choices in a menu:
1. Reset the Test Tool.
2. Open a menu, for example, press
The menu shown in Figure 4-1 opens.
A yellow background or yellow characters mark the active functions. If more
than one menu group is available, they are separated by a vertical line.
The menu shown indicates that
shows the result of a V rms measurement (
3. Press or
4. Press ENTER to confirm the selection.
The active function in the next menu group is highlighted. If the confirmation
is made in the last (most right) menu group, the menu will close.

Standard Test Tool Setup

Before you start the verification procedure you must define a standard Test Tool
setup, for example, SCOPE 1. During verification you will be asked to recall this
setup. This defines the initial Test Tool setup for each verification.
Press ENTER to confirm each setting.
The setup steps for channel C and D are only for the models
190-104, 190-204, and 190-504.
Proceed as follows to create a setup (for instance SCOPE1):
1. Reset the Test Tool. Input A is ON and other inputs are OFF.
B
2. Press
the actual settings.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCOPE
READING 1
to highlight the function to be selected.
Figure 4-1. Menu Item Selection
Note
: . The black text with yellow background indicates
INPUT B ON
Performance Verification
Operation Instructions
and press F2 (
READING
(that is the upper left reading)
) on Input A (
V ac+dc on A
ws-Read2.BMP
4
...).
).
4-5