JUKI AE-10 Instruction Manual page 25

(2) In case of SC-922 motor
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the Instruc-
tion Manual for the operation panel to be used.
1
C
D
(Caution) Be sure to re-turn ON the power switch when one or more seconds have passed after turning it
OFF. If the power switch is re-turned ON immediately after turning it OFF, the sewing machine
may fail to operate normally. In such a case, be sure to turn ON the power switch again properly.
switch 2 . Select function number "167 (enable/disable bobbin thread remaining amount de-
2) Press
tecting function)." Press
switch 2 . Select function number "168 (bobbin thread remaining amount detecting function)."
3) Press
switch 4 to select the setting "0 (disable stopping of sewing machine) or "1 (enable stopping
Press
of sewing machine)."
switch 2 . Then, turn OFF the power switch.
4) Press
SC-510
Function No. Function No.
57 167
0
1
2
A
7
switch 4 to select the setting "1 (enable detecting device)."
SC-922
Function No.
168
Bobbin thread remaining amount detecting function is set to inopera-
0 0
tive.
The bobbin thread remaining amount detecting function is enabled.
Sewing machine does not stop even when it is detected that the
1 0
bobbin thread has run out. At this time, the detecting switch fl ashes
on and off, and the buzzer sounds "four times".
The bobbin thread remaining amount detecting function is enabled.
Sewing machine stops when it is detected that the bobbin thread
has run out. At this time, the detecting switch is lit up, and the
buzzer sounds "one time". In addition, sewing machine operations
1 1
other than the presser lifting operation by means of the pedal can-
not be performed. When sewing is desired to be reopened, press
the detecting switch once to make the detecting switch fl ash on
and off. Then sewing machine operation can be performed.
1) Tu r n O N t h e p o w e r w i t h
B
switch 7 held pressed. When you
have kept the switch held pressed
for three seconds or more, the buzz-
er sounds to allow you to carry out
service-level function setting.
(Indication item A displays the last
item you have changed the setting.)
* If the display shown on the screen
does not change, turn the power
supply OFF and carry out operation
1) again.
Motion
22
– –