Hardware Installation Verification - Avaya 5000 Series Installation Manual

3. Tighten the screws on top of the adapter terminal block to secure the DC leads.
4. Attach the opposite ends of the leads to a –48V DC power source.

Hardware installation verification

Checking LEDs
This procedure describes how to check and interpret LEDs on the 5000 Series switches.
To check and interpret front panel LEDs, compare the LEDs to the tables in the Job
Aids section.
Job Aid
The following tables describe the LED indicators.
Table 10: Job aid: Switch LED state indicators
Label
UI button
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
Pwr
Avaya Ethernet Routing Switch 5000 Series Installation
Color / Status
White/steady Power is on.
Off Power is off.
Green / steady The switch is connected to AC power and is receiving
power.
Green / blinking Problem with primary Boot image. Booted from back
up image. Configuration and agent code may be
incorrect.
Amber / slow blinking System will reset in less than 3 seconds. To stop the
reset, release UI push button.
Description
Note:
The UI button is labeled Mode Select on Avaya
branded equipment.
Hardware installation verification
December 2010 75