Installing A Front Mounted Switch In An Equipment Rack - Avaya 5000 Series Installation Manual

Procedures for installation of the switch
Figure 12: Wall mount mounting screw location

Installing a front mounted switch in an equipment rack

This procedure describes how to install a front mounted switch in a rack.
Prerequisites
#2 Phillips screwdriver
1. Attach a bracket to each side of the switch using a #2 Phillips screwdriver as
2. Slide the switch into the rack as illustrated in
Job Aid
The following figures show the bracket installation.
66 Avaya Ethernet Routing Switch 5000 Series Installation
illustrated in Figure 13: Bracket installation
holes goes on the right side of the switch, where the round fan vents are located.
Insert and tighten the rack-mount screws with a #2 Phillips screwdriver.
on page 67. The bracket with the round
Figure 14: Rack mount on page 68.
December 2010